|
Safecoat DuroStain is a premium quality, fast curing flat finish semi-transparent stain for interior and exterior surfaces. It promotes penetration of porous surfaces and has high adhesion for superior protection as a decorative colorant. It contains no aniline dyestuffs, no gilsonite or asphalt, no aromatic solvents and no formaldehyde For use on: Safecoat DuroStain is recommended for all wood surfaces. Coverage: - One quart of Safecoat DuroStain covers approximately 75 square feet in one coat depending on surface porosity and the intensity of the stain color desired. - Excellent pigmentation stability. - Safely used by and for the chemically sensitive. - Low odor, non-offensive to installer and occupant. - Very low VOC content, meets or exceeds all federal and state air quality regulations, including California. Surface Preparation: Surfaces to be stained with Safecoat DuroStain should be sound and cleaned of dirt, dust, grease, wax, silicone, soap and oil, and must be completely free of mold, mildew or fungus contamination. Cleaning with an odorless, dye-free, all-purpose cleaner like SafeChoice Super Clean is recommended. Before application, it is very important to test DuroStain in a small section of the surface to be stained to be sure shade and intensity of color is acceptable. Previously painted or sealed surfaces will not accept stain readily. Consequently, stripping of old paint or sealer followed by rinsing and sanding will be required before application of Safecoat DuroStain. Surface should be dry before application. Application: Always have adequate ventilation. Before using, stir Safecoat DuroStain well, then apply it evenly without reduction using a high quality nylon or synthetic bristle brush. To adjust intensity of color, best results will be obtained by staining six foot sections (2. x 3.) of the surface and wiping off excess stain while it is still wet to achieve the desired intensity of color. Always keep a wet edge. Darkness of stain may be increased by high surface porosity, wiping off less stain, or letting the stain dry longer before wiping. The shade of the stained surface will be affected by the color and type of wood. Reduce if desired for spraying with up to 1/2 pint of water per gallon. Always use a painter.s mask when spraying. Do not apply in direct sunlight. Make sure to wipe off any excess stain which does not penetrate into the wood. (please look at our rules and privacy policy) |
S_Sandoval@machine--tools.com (Saundra Sandoval) for additional information. This email is used for forwarding to newsgroup user.
