|
LPCEB2000-S is an industrial-oriented processor board designed around Philips LPC2129/2114/2119/ 2124/2194 ARM7TDMI-S, 32-bit, 60MHz microcontroller. This board has various peripherals which are accessible via pin-headers on the edge, that means you have tremendous flexibility to extend the system to interface with your peripherals.Users can embed this processor board in their designs to form a complete hardware system. This board will speed the development process and reduce time to market alongwith product prototyping and manufacturing costs. * Dimensions: 65 x 61 mm, Temperature: -45 to +85 Celsius * LPC2129 CPU, 32bit, 60 MHZ, 256KB internal flash, 16KB SRAM. Can be replaced with LPC2114/2119/2124/2194 CPU. * Powered with a regulated 5V DC using the on-board 1.8V and 3.3V regulators. * Power status indicator LED(D2) * A Jtag enable/disable jumper * J1 and J2 Connector, both use 0.1 spacing, 0.025 square inch straight pin headers. J1 is 20x2 Pins, J2 is 10x2 Pins. Signals routed to J1 and J2, as shown below: Philips LPC21xx Microcontroller Not support memory outside chip LPCEB2000-I Development Board for LPCEB2000-S: The LPCEB2000-S can plug onto LPCEB2000-I Development Board via J1 and J2 connector header when developing. LPCEB2000-I Development Board expand the two UART to RS-232 drivers, provides connections to 1 CAN port(only for LPC2119/2129/2194), 4x4 keyboard, 2-channel PWM output(one is output to a buzzer, the other is to PWMDAC), 2-channel AD sampling input, I2C bus, 8-digit 8-segment LED display, Analog signal output to a speaker, 20 PIN standard JTAG port and 1 reset button. Plenty of software examples(all in source codes) are also provided with the LPCEB2000-I Development Board. With the LPCEB2000-I Development Board, you can develop the LPCEB2000-S quickly. You must have a return authorization number to return your product. Please contact k_heath@machine--tools.com to obtain an authorization number, which shall be valid for 14 days after issued. This product is covered by a warranty of 12 months. You must have a return authorization number to service your product. Please contact k_heath@machine--tools.com to obtain an authorization number. (please look at our rules and privacy policy) |
k_heath@machine--tools.com (Karina Heath) for additional information. This email is used for forwarding to newsgroup user.
